How to Start VPS in Rescue Mode Using Virtualizer

Rescue mode can be used for data recovery, OS repair, etc. You can enable rescue mode on your VPS. Please, follow the below steps.

1. Log in to your Virtualizor Control Panel.

2. From the left side panel, click on List VPS.

3. Hover your mouse on the appropriate VPS, and that line will be highlighted. Then click on the Manage icon in the highlighted line.

4. Click on Rescue Mode.

5. Enter the password and choose Enable Rescue Mode.

It can take a few minutes for it to take effect. After that, you can access your VPS via SSH with your new password. In case SSH is not accessible, you can access it from VNC.

To disable rescue mode, you can go back to the rescue mode tab and click on Disable Rescue Mode.

If Virtualizor shows that no actions are allowed, you can click on the Reload this page icon to refresh your page. All actions will become visible after disabling rescue mode.

  • 0 Users Found This Useful
這篇文章有幫助嗎?

相關文章

How to Reinstall an OS Using the Virtualizor Automatic OS-Reinstaller

You can easily Install/Reinstall the operating system using the Virtualizor. However, note...

How to Access VPS via VNC in Virtualizor

You can access your VPS via VNC in an emergency, such as when a firewall blocks your IP, the...

How to Change the VNC Password in Virtualizor

You can change the VNC password using Virtualizor. 1. Log in to your Virtualizor Control...

How to Set Self Shutdown/Start/Reboot Timer for Your VPS in Virtualizor

Do you know that you can set a self-timer for the VPS to start/shutdown/reboot or Power off at...

How to Start/Boot Your VPS in Virtualizer

If your VPS is down/offline, you can start it using Virtualizor. 1. Log in to your...